OpenSeaMap Forum

For new registrations: Please create and activate an account. Afterwards send an email to forum.openseamap@gmail.com including a short message and your username to get write access to this forum. Thanks!
Für neue Registrierungen: Bitte erstelle einen neuen Account und schalte ihn frei. Anschließend sende eine kurze Mail mit deinem Nutzernamen an forum.openseamap@gmail.com um Schreibzugriff für dieses Forum zu bekommen. Danke!

You are not logged in.

#1 2012-11-11 11:27:48

skippern
Member
Registered: 2012-11-03
Posts: 38

Cables and pipelines

Looking at the current rules.c it seems like cables (both subsea and overhead) and pipelines are suppressed. Any reason for that? I have mapped a lot of cables and pipelines in Brazil, specially the port of Rio de Janeiro, where oil, gas and chemical terminals are located on isolated piers in the middle of the bay, treatment and storage facilities on small islands, and export lines to consumers on main land.


A. Johnsen aka Skippern
Master Mariner, MWS, Marine Consultant

Offline

#2 2012-11-11 13:50:17

malcolmh
Member
From: Hull, UK
Registered: 2012-09-05
Posts: 194

Re: Cables and pipelines

The reason is that these objects cause the renderer to slow down to a crawl, causing backlogs to build, often taking several days to clear. I am working on a new renderer that will overcome this problem, but it is unlikely to be commissioned until sometime next year. Please keep mapping these objects, as they will be retro-actively rendered once the new renderer is in service.


Malcolm Herring, Developer

Offline

Board footer

Powered by FluxBB